860 DSPh Firmware Update History
Listed below is the history of updates available for the 860 DSPh Firmware. For assistance with any installation, please call tech support at 1-800-344-2412.
September 2007
- Improved Switch Calibration when using 1x4 or 1x16 switches
November 2006
- Incorporated latest Signal Level Driver
- Incorporated latest Enhanced Digital Video Board Driver (IL-X)
- Added Unit Startup Time to Info Web Page
- Added Trilithic Graphic to Home Web Page
- Enhanced Scanning and Trap issuing algorithm (increases speed)
- Eliminated the potential for Internet communication breakdown due to network latency by accommodating packet delay through extended DSPh wait time
- Fixed the Annex A BER math
- Changed all measurement modes and data gathering to be more efficient, quicker, and more accurate. This is a significant change in measurement techniques by optimizing memory, measurement time, and Main Processor / DSP synchronization
- Fixed Audio measurements below -20dBmV on channels wider then 6MHz
July 2006
- Remote Control Function now supports Firefox 1.5.0.4, Internet Explorer 6, and Internet Explorer 7 Beta
- Starting with this firmware release, you can upgrade either your 870 MHz or 1000 MHz meters (860 DSPh) with the same firmware and algorithms.
- Formal CI-4 Support
- Red LED now will blink on error conditions as follows:
- Unsupported Hardware (5 blinks) - Should only be seen at the factory
- Flash Drive Needs Formatting (4 blinks) - Should only be seen at the factory
- Hardware Malfunction (3 blinks) - Over Temp, Under Voltage, etc
- User Configuration Problem (2 blinks) - No channel plan, No Network Config, No SNMP Config
- User Configuring Device via Serial Port or Network Connection (1 blink) – WorkBench or HyperTerminal
- Solid Red - Device Operating Normally
- Green LED provides Status as follows:
- Off – Unit is in Idle Mode (not measuring anything)
- Blinking – Unit is in Scanning Mode (normal operation)
- Solid Green – Unit is in Live mode (lasts up to 1 minute)
